Doublemassa – New England's Narrow Road

Modeling Photos of the Doublemassa Hat

The Doublemassa massive hat knitting project is done. I have to model it for the full effect, so here goes.

Don’t get excited, no gorgeous models here. But the Doublemassa deserves to be photographed while worn. I’m the only one around to do it, so here goes.

I’m a little late posting this because life got busy! But I do need to share the final photos of this knitting project.

Tips For Finishing the Hat

First a note on finishing up this knitting project. One key thing I want to mention is to be sure and weave in your ends BEFORE you make decreases at the crown. I spit spliced my wool, and only had two ends to weave, but I had to pull that section up through the crown opening.

I ended up pulling the whole hat out just to check for ends. Maybe next time weave as I go, or at least keep track of how many ends there are. Wool makes yarn splicing easy, and this means fewer ends hanging.

two ends to weave in — Only 2 ends to weave

Doublemassa hat inside out. — Only 2 ends to weave

As I began the crown decreases, the hat was finally long enough to fold the brim and try on. This hat is seriously cool! It fits like a charm too. I’m knitting it for my daughter and she has a small head. I hope she likes the fit. The Rauma wool is quite soft, so no itchy problem there. I highly recommend Rauma.

Photo below: At this point all I have left to knit is the crown decreases. I’ve swapped out the 16″ circular for DPNs. Once that is finished I need to make a fun tassel for the top.

Making the Tassel

Tassel directions are included in the Hat’s On book. However, the directions are not great. I found a good video to follow, but the tassel must be attached to a hat without an inside access. I wrote a blog post about making and attaching the tassel.

Washed and Blocked

Fontana immediately claimed the hat as her newest cat bed!

Doublemassa colorwork snowflake hat knitting is complete — Unwashed

Thick brim in colorwork snowflake design of Doublemassa hat — Unwashed

Modeling the Hat

I hate to show too much of myself, but in this case the Doublemassa deserves to be shown on a head. My head was it, so here goes.

All my knitting photos are selfies. I prop the camera somewhere and use the 3, or 10 second delay. Usually I go outside, unless it’s too hot. Then I do a lot of cropping and fixing, … oh and deleting too!

These photos would look a lot better with a snowy background and me wearing a puffy winter coat. Instead it was a hot, cloudy morning.

The Doublemassa really is an impressive pattern. I used colors I already had, but this would be pretty in many combinations. The pattern is available in the Hat’s On book (paid link) by Charlene Schurch.

If, as a knitter, you get a request for a hat that is warm over the ears – this is it! I don’t know how you get much warmer than a 4-layer fold.

Knitting Stories continued…

Year-Round Camping in Florida; Enjoying Nature While I Knit

12/16/2025

Knitting Project Review: Magnolia Chunky Cardigan

11/12/202511/28/2025

Camel Yarn Weekend Hat Project

11/04/2025

Pattern Review: Beginning the Magnolia Chunky Cardigan

10/16/202510/29/2025

Three Knitting Projects On My Needles in September

09/17/202510/04/2025

First Attempt at Knitting Clotilde

09/06/2025

Something went wrong. Please refresh the page and/or try again.

How to Add the Tassel to The Doublemassa Hat

How to make a tassel for a knitted hat. Finding a way to attach the tassel to a lined hat with no underside access.

Making a tassel is not difficult, and I was looking forward to making the one for my Doublemassa. But there was a problem. How is a tassel added to this type of knitting project?

I have now assembled the tassel (and it’s far from perfect looking). But, my big problem is how to add it to this hat. Ordinarily, when finishing up a hat, you have an underneath, or wrong side, where the yarns are pulled through and tied off under the crown. The Doublemassa is knit in a way that the underneath can’t be accessed. It is completely closed up. The pattern is no help.

Tassel Making Video

It was hard to envision tassel making in the Hat’s On book where the Doublemassa pattern is found. This video on YouTube was very helpful. However, I still must figure out how to add the tassel to my finished hat.

One of the Doublemassa knitters mentioned opening up the top of the hat and making a big knot to tuck through. Then, she closed up the top again. I ended up doing this, but a little differently.

My Tassel

I wrapped both yarn colors 60 times around a six inch cardboard. I tied two strands of yarn around the top and then braided the 4 strands. I wish I’d used more strands for this.

Next I wrapped the blue yarn around the tassel.

wrapping blue and white yarn for making a tassel — Wrapping yarn

I do not have a bodkin (Amazon paid link), which is a special flat “needle” which is used by the woman in the video. My larger sized embroidery needle worked fine. This is used to wrap the tassel and tuck the yarn down inside.

After my washed hat was dried, I noticed that two stitches at the very top were loose and not bound off! Somehow they did not unravel (wool is so awesome). It left a small opening.

attaching a tassel — Two loose stitches!

hat tassel attached to Doublemassa — Two loose stitches!

Adding the tassel was a challenge, but I simply did as one of the other knitters mentioned. I made a big knot and pushed it through the top. My dropped stitches mistake turned out to be the thing that saved me. Then I used the two yarns, one blue and one off-white, to close up the top tightly. I wove the ends down through the hat and cut the yarn.

A Better Way to Attach The Tassel

Now that I have done it, I feel lucky that it worked out. And I know that there is a better way to achieve this. The pattern simply says make a tassel and attach it – which is very unhelpful.

My advice is this: When knitting the last rounds of the crown, do NOT close up the top of the hat. Leave a tail and tuck one tail down inside the hat. Put the open stitches onto plastic holders, or waste yarn, for washing.

Make the tassel and wash the hat.

Once the hat is washed and dried, open the top and tuck the knotted end of the tassel braid down into the hat. Use the remaining yarn tail to close up the top.

Alternatives

A few of the Doublemassa hat knitters decided to begin knitting the hat with the colorwork. By using a provisional cast on, the lining of the hat could be knit last. This would do away with the need to begin the hat with a tiny disappearing loop cast on, and magic loop knitting.

Keep reading

07/07/202507/06/2025

Something went wrong. Please refresh the page and/or try again.

Getting There on the Doublemassa Knitting Project

An update on my latest hat knitting project. This one is a very long hat called the Doublemassa.

The dark blue yarn skein is just about finished up. This morning was quite chilly for a March morning in Florida. I was bundled up in my newest Warm Up sweater, hat and mitts while I checked on the garden and filled the bird feeders. I decided to show my progress on the Doublemassa hat.

Fair Isle tube hat knitting in navy blue and off-white.

As you can see this is a very long hat! It looks huge, and I am hoping it will fit properly.

The colorwork designs are pretty cool, and I just finished up the birds rows. When looking at this hat finished, on Ravelry, the brim will fold up to either the birds or the hearts (which I have not even begun yet)!

Here is how the hat will fold: From the top of those snowflakes down, everything is tucked up inside. Then the snowflake brim part will be folded out and up. The snowflakes will cover most of those two colorwork sections above the snowflakes. This creates 4 layers of fabric at the brim. I’m not good at visualizing this and can’t wait to actually do it.

Even though this hat is already quite long, I have many rows of colorwork left to knit. It’s been a very fun pattern, as I love doing Fair Isle. The Rauma yarn is quite awesome as well.

As I knit more, I will be attaching a new skein of blue, and will probably need more of the natural color eventually.

Keep reading

04/27/202005/09/2020

Something went wrong. Please refresh the page and/or try again.

Doublemassa is The Hat of My Dreams

Beginning the lined, Doublemassa hat pattern. It is a stocking cap done using two different yarn colors.

The hat pattern book “Hats On!” has provided loads of fun hats to knit. I have already knit quite a few, and a few more than once. My favorite of all the hats has always been the pink one featured on the front of this book. It is named the Doublemassa.

Way back when I purchased Hats On! I was a beginner knitter. Many of the patterns in the book seemed too difficult and involved reading a chart. I hadn’t mastered that yet, so I stuck to knitting the simpler beanies. It has taken many years to work my way up to attempting the Doublemassa.

Doublemassa Difficulty Rating

There is a lot to this hat pattern. I don’t recommend it for beginners.

This colorwork hat is knit using a chart. A long chart. The anatomy of the Doublemassa is this. It is a short-ish stocking cap. It has a fold up wide brim that is 4 layers thick. Two yarn colors are used for the colorwork and there is a lining. The pattern begins with the lining being knit from the top-down. Once the lining is complete, the colorwork begins. A tassel is added at the end.

This hat book is full of various types of hats, but honestly, the directions are not in depth. For example, in the case of the Doublemassa pattern, we begin by knitting the lining as a top-down hat. We cast on only 12 stitches and knit in the round while expanding (4 each round) with yarn-overs.

I used the Disappearing Loop cast on, by rewatching this video by Always Knitting. This is the same cast on I used for the Musselburgh Hat. It allows for knitting in the round from a very small circumference outward. It also involves Magic Loop. This type of cast on is fiddly no matter how you do it! I used a tiny crochet hook to help.

Doublemassa hat knitting — Disappearing Loop

The pattern simply says to expand by 4 stitches using yarn overs. Since it’s a lining, and won’t be seen, I was not very careful about spacing my beginning increases evenly. Those yarn-overs need to be knit through the back loop, or else a hole is created. This is something the writer assumes we know.

As I read on, the colorwork part has various rows where decreases are made. All the row says is “decrease – with the number”. So let’s say there are 130 stitches and I need to evenly decrease by 6 stitches. I’m going to use the Knitulator to space my decreases. (Or, divide by 6 to estimate.) Most decreases are 2 or 4 which are easy to figure.

Blue colorwork on Doublemassa hat — Did colorwork wrong

Ripping back colorwork to begin again — Did colorwork wrong

Yarn

I’m using three skeins of Rauma Finull, which is a fingering weight, rustic wool. I dug into my stash and had enough of the natural beige heather to be the main color and lining. I’m using a dark blue as the contrast color.

Needle size is 4, but I’m not sure if I will go up a size when it comes to the colorwork. (I did not change the needle size.) My daughter’s head is small, so I may stick with the size 4. She has been asking for another hat with a brim for ear warmth. Doublemassa should work nicely.

The folding of the hat is hard to figure out, by looking at the photos. I guess it will be obvious when it’s done. I have quite a few patterns in the works now, so it may be a while before this one is finished.